Inserting/Replacing Activated Charcoal Filters - hanseatic SY-103E6-E33-C55-L52-600 Gebrauchsanleitung

(13)
(15)
5. Once the grease filters (15) are fully dry,
insert them with the pins into the open-
ings.
6. Push the locks (14) down; snap the
grease filters (15) in and release the
locks.
7. Close the cover (13) again and allow it to
click into place.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
Activated charcoal fi lters are required for
circulation air operation. They help combat
odours. They have to be replaced as soon
as the cooking odours can no longer be
adequately fi ltered.
If used frequently, you should change the
fi lters regularly. Check them at least every
6 months.
For the source of supply, please see chapter
"Our customer service" on page GB-22.
1. Unplug the mains plug or switch off the
corresponding circuit.
(14)
Care and maintenance
(13)
2. Flip the cover (13) up.
3. Push down the locks (14) on the grease
filters (15) and carefully remove the
grease filters (15).
4. Only when replacing: The two charcoal fil-
ters (23) are located to the right and left of
the motor (24). Loosen the two charcoal
filters and remove them.
(24)
(23)
5. Place the new charcoal filters to the right
and left of the motor and tighten them in
an anti-clockwise direction. Allow the lock
to click into place.
Page GB-19
(14)
(15)
(23)