Before Getting Started; Place The Drill Holes - hanseatic SY-103E6-E33-C55-L52-600 Gebrauchsanleitung

Page GB-12 Assembly

Before getting started

• Read chapter "For your safety" on page
GB-4 and all the safety notices.

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the stovetop.
2. Draw the six drill holes on the wall, fol-
lowing the diagram on page 12. Make
sure the distances between the holes are
correct.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.