Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-18
Care and maintenance
(13)
(14)
5. Place a grease filter (13) with the pins into
the openings.
6. Push the lock (14) down; snap the grease
filter (13) shut and release the lock again.
7. Repeat the last two steps for the second
grease filter.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
The activated coal filters remove odours. They
have to be replaced as soon as the cooking
odours can no longer be adequately filtered. If
used frequently, you should change the filters
regularly. Check them at least every 6 months.
For the source of supply, please see chapter
„Our Service Centre" on page EN-21.
1. Unplug the mains plug or switch off the
corresponding circuit.
(14)
2. Open the lock (14) on one grease filter (13)
and carefully remove the grease filter.
3. Repeat this step for the second grease
filter.
4. Only when replacing: Loosen the activated
charcoal filters (15) in a clockwise directi-
on and then remove them.
5. Place the new activated charcoal fil-
ters (15) to the right and left of the motor
as shown and tighten them in an an-
ti-clockwise direction. Allow the locks to
snap into place.
(13)
Werbung
Inhaltsverzeichnis
