Inserting/Replacing Activated Charcoal Filters - hanseatic SY-103E9A-P1-C84-L121-600 Gebrauchsanleitung

Page EN-10 Operation
5. Place the grease filter (17) with the pins
into the openings.
6. Slide the lock (16) to the left; snap the
grease filter (17) in and release the lock.
7. Close the cover (15) again and allow it to
click into place.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered. If used frequently, the filters should be
renewed regularly or at least checked every 6
months. For the source of supply, please see
chapter „Our Service Centre" on page EN-21.
1. Unplug the mains plug or switch off the
corresponding circuit.
(15)
(16)
(17)
2. Flip the cover (15) up.
3. Open the lock (16) on the grease fil-
ter (17) and carefully pull the grease filter
(17) downwards to remove it.
4. Only when replacing the charcoal filters:
The two activated charcoal filters (19) are
located to the right and left of the motor
(18).
Loosen the two activated charcoal filters
and remove them.
(19)
5. Place the new activated charcoal filters to
the right and left of the motor and tighten
them in an anti-clockwise direction. Allow
the locks to click into place.
(15)
(16)
(17)
(18)
(19)