Inserting/Replacing Activated Charcoal Filters - hanseatic SY-3503C1-P1-C81-L22-600 Gebrauchsanleitung

(16) (17)
5. Place a grease filter (16) with the pins into
the openings.
6. Push the lock (17) down; snap the grease
filter (16) shut and release the lock again.
7. Repeat the last two steps for the second
grease filter.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered.
If used frequently, you should change the
filters regularly. Check them at least every
6 months.
For the source of supply, please see chapter
"Service" on page GB-20.
1. Unplug the mains plug or switch off the
corresponding circuit.
Care and maintenance
(17)
2. Open the lock (17) and carefully remove
the grease filter (16).
3. Repeat this step for the second grease
filter.
4. Only when replacing: Release the two
coal filters on the left and right of the mo-
tor and take them out.
(19)
(18)
5. Place the new activated charcoal filters
(18) to the right and left of the motor (19)
as shown and tighten them in an anti-
clockwise direction. Allow the locks to
snap into place.
Page GB-17
(16)
(18)