Attaching The Exhaust Air Hose; Installing The Flue Screen - hanseatic SY-103E6-E33-C55-L52-600 Gebrauchsanleitung

Page GB-14 Assembly
8. Place the grease filters (15) with the pins
into the openings.
9. Push the locks (14) up; snap the grease
filters (15) in and release the locks.
10. Close the cover (13) again and allow it
to click into place. The exhaust hood is
now mounted to the wall.
Attaching the exhaust air
hose
The exhaust air hose (4) must be installed
if you intend to use the exhaust hood with
exhaust air operation.
(4)
1. Insert the end of the exhaust hose (4)
with the larger diameter (153 mm) into the
connection with the check valve.
2. Secure the lower end of the exhaust hose
with the cable tie (9).

Installing the flue screen

(6)
1. Screw the wall mount for the upper flue
screen (6) into the prepared dowels using
2 round-head screws (10).
2. Push the upper part (2) of the flue screen
halfway into the lower part (3) of the flue
screen.
(9)
3. Place the retaining plate (7) onto the low-
er flue screen (3) so that it lines up with
the chamfers on the inside. (Screws and
elongated holes should point upwards).
4. Turn two plate screws (8) from the outside
through the retaining plate (7) and the
lower flue screen (3). Tighten the screws
somewhat, but only loosely.
(2)
(3)
(7)
(8)
2x
(3)