Operating The Model; Inserting And Connecting The Flight Battery; B) Setting The Centre Of Gravity; C) Setting The Rudder Deflections - Reely SKY Nemo Bedienungsanleitung



9. Operating the Model

a) Inserting and Connecting the Flight Battery
After removing the canopy, the flight battery is pushed into the fuselage from the front and secured with hook-and-loop tape.
The precise position of the rechargeable battery is determined by the centre of gravity.

b) Setting the Centre of Gravity

The flight battery must be installed in the battery compartment so that the centre of gravity is approx. 60 - 75 mm behind the leading edge of the wing. To do so,
mark the corresponding centre of gravity position on the ribs of the wing. Use your index fingers to hold the assembled and ready-to-fly model from below at the
measured positions. If the centre of gravity is set correctly, the model should be leaning slightly forward.
Important!
Always measure the centre of gravity with the cabin hood in place.
For the first flights, please set the centre of gravity at 60 mm. The best centre of gravity then can be reset
slowly.
During flight, the battery must be secured with adhesive tape so it does not come off. In addition to the
described hook-and-loop tape, you may additionally secure the battery with the hook-and-loop tape at the
battery cute.
Practical advice: When you have determined the centre of gravity, mark the flight battery and the fuselage
using a pen. Thus, when you change the flight battery, you do not have to determine the centre of gravity
again.

c) Setting the Rudder Deflections

When the construction is performed correctly and the transmitter set, the rudders should have the following deflection values (measured at the rear edge):
Aileron 12 mm upwards
Elevator 12 mm upwards
Side rudder 20 mm to the left
Attention!
The indicated values show the lower and the upper thresholds of the rudder deflections. Adjust the deflections individually to suit your personal
preferences. Use a computer remote control for your model to comfortably set the values from the transmitter. If you are using a normal remote
control, the values are set by repositioning the push rods on the servo arms or the flaps.
32
12 mm downwards
12 mm downwards
20 mm to the right
Figure 16