Alarm Function - Conrad WB92 Bedienungsanleitung

f) Alarm Function
Displaying the Alarm Time
Push the button „MODE/SET" (B2) briefly several times to switch between the time display with
second or weekday and the alarm time display („AL" is displayed in the seconds position).
Setting alarm time
• When the alarm time is displayed (e.g. „06:30 AL", keep the MODE/SET" (B2) pushed for
about 3 seconds until a sound signal is issued and the hours of the alarm time flash. Release
the button again.
• Set the hours of the alarm time with the button „+" (B4) or „-" (B5).

Keeping the respective button down for some time will adjust quickly.
If you do not push any button for about 15 seconds, the weather station saves all
input and leaves the setting mode automatically.
• Briefly push the button „MODE/SET" (B2); the displayed minutes of the alarm time flash. Set
the hours with the button „+" (B4) or „-" (B5).
• Push the button „MODE/SET" (B2) briefly again to save all settings and leave the setting
mode (alternatively, wait for a few seconds without pushing a button).
After a few seconds without pushing a button, the display of the alarm time switches back
to the time display automatically.
Switching the Alarm Function On/Off
• When the alarm time is displayed (e.g. „06:30 AL"), briefly push the button „ALARM ON/OFF"
(B4) to switch the alarm function on or off.
• When the alarm function is active, the icon „
48
" appears above the time display.