Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
to use your food
chopper
The knife blade unit comes in 2
parts, a lower and an upper blade.
For coarser chopping use the lower
G
blade on its own.
For finer chopping or pureeing use
G
both blades together. This will also
give a faster result. To use both
blades fit the upper blade onto the
lower blade and turn anti-clockwise
to locate in place
the blades are sharp.
Note: After processing food, the
upper blade may disengage from the
lower blade. This is normal as the
blade assembly is designed to be
loose fitting to ease separation after
use.
1 Fit the bowl onto the power unit,
.
then turn clockwise to lock into
place
2 Fit the blade assembly into the bowl.
Always fit the bowl and blade
G
assembly onto the food chopper
before adding ingredients.
3 Cut the food into suitably sized
pieces and place in the bowl. Larger
pieces of food should be cut into
approximately 1 to 2 cm pieces.
4 Fit the lid and turn clockwise to lock
into place
.
5 Connect to the power supply and
press down on the speed selector to
select the desired speed
Press the speed selector lightly to
G
obtain speed 1.
Press the speed selector firmly to
G
obtain speed 2.
Alternatively the speed selector may
G
be pressed down for short periods
of time to produce a pulsing action.
This can be used to avoid over
processing food.
6 Operate the food chopper until the
desired result is achieved.
7 Reverse the above procedure to
dismantle the unit.
. Take care as
.
Always unplug the food
G
chopper before removing the
lid.
important
If preparing food for babies or young
G
children, always check that the
ingredients are thoroughly blended
before feeding.
Do not run the food chopper
G
continuously for longer than
60 seconds. Leave to cool for
2 minutes in between each
60 second operation.
Do not operate the food chopper if
G
the bowl is empty.
Always allow hot food to cool before
G
processing.
Do not exceed the maximum
G
capacities stated or fill above the
500ml level marked on the bowl.
Do not place any part of the
G
chopper in the microwave.
hints
If the chopper labours, remove some
G
of the mixture and continue
processing in several batches,
otherwise you may strain the motor.
When making mayonnaise, put all
G
the ingredients except the oil into the
bowl. With the food chopper
running, add the oil slowly down the
oil feeder cup
supplied.
Remember that chopping hard foods
G
such as coffee beans, spices,
chocolate or ice will wear the knife
blades faster.
Beware of over processing some
G
ingredients. Stop and check the
consistency frequently.
Various spices such as cloves, dill
G
and cumin seeds can have an
adverse effect on the plastic of your
food chopper.
To ensure even processing, stop and
G
scrape down any food from the side
of the bowl with the plastic spatula
supplied.
The best results are obtained by
G
chopping small quantities at one
time.
3
- see recipe
Werbung
Inhaltsverzeichnis
