Changing/ Replacing Filter; Troubleshooting - Kärcher IV 100/55 H B1 Betriebsanleitung

Changing/ replacing filter

Warning
Do not reuse the main filter element after it
has been removed from the appliance.
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
 At the lower end, loosen and pull out the
hose to the suction turbine.
1 Handle for filter cleaning
2 Spring
3 Fastener for filter dedusting
4 Lock
5 Lid of filter chamber
 Tilt the fastener for filter dedusting to-
wards the side.
 Unscrew the handle for filter cleaning.
 Remove the spring.
 Unscrew the nut below the spring (you
will need a spanner with width 27 mm).
 Open locks.
 Remove the lid of the filter chamber.
1 Frame
2 H filter cartridge
3 M filter
 Remove the H filter cartridge upward.
 Immediately place the H filter cartridge
into the included bag and close it after
you remove it.
 Dispose of the used H filter cartridge in
a dust-tight bag according to the statu-
tory provisions.
 Open the knot of the tapes on the filter
and remove the frame.
 Remove the M filter.
 Immediately place the M filter into the
included bag and close it after you re-
move it.
 Dispose off the used M filter in a dust-
tight bag according to the statutory pro-
visions.
 Insert and secure the new filter in the re-
verse sequence of steps.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Danger
Have all checks and works on electrical
parts parts performed by an expert.
Note: In case of a failure (e.g. filter break-
age) the appliance must be turned off im-
mediately. The failure must be remedied
before the appliance is put into operation
again.
Motor (suction turbine) does not
No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
Protective motor switch was triggered.
 Reset switch.
– 8
EN
start
21