Transport; Storage; Care And Maintenance; Changing/ Replacing Filter - Kärcher IV 60/30 Originalbetriebsanleitung

 Pull out the vacuuming material con-
tainer from the appliance using the han-
dle that has been provided for the pur-
pose.
Note: The vacuuming material container
must be emptied if it is filled to approx. 3 cm
below the upper edge.
 Empty the vacuuming material contain-
er and insert it back into the appliance
using the reverse sequence.
Dust collection bag
You can insert a dust collector in the vacu-
uming material container to empty the ap-
pliance without causing dust.
 Insert the dust collection bag into the
container and attach it carefully to the
container wall.
 Put over the edge of the bag over the
rim of the vacuuming material container.
 Insert the vacuuming material container
back into the appliance.
 After finishing use, close the dust col-
lection bag and remove it from the vac-
uuming material container.
 Dispose off the dust collection bag with
its contents according to the applicable
regulations.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Release the park brakes and push the
appliance by the push handle.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Cleaning the filter
 Move the lever for cleaning the filter
back and forth a couple of tomes.
If this cleaning does not lead to improve-
ment, the filter can be removed and
washed or replaced (see Chapter "Ex-
changing/replacing the filter").

Changing/ replacing filter

 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
 Open the locks (A) on both the sides.
 Remove the suction head. Ensure that
the mains cable is not damaged.
– 5
EN

Storage

15