C) Installing The Speed Controller; Installing The Receiver - Reely Deathwatcher EVO Bedienungsanleitung

c) Installing the Speed Controller

The speed controller can be attached on the upper chassis plate. Use double-sided adhesive tape or suitable hook-
and-loop tape for this.
The on/off switch of the speed controller must be installed so that it can be reached easily with the car body attached
as well. Depending on the build of the on/off switch, it can also be attached to the chassis with double-sided adhesive
tape or a piece of hook-and-loop tape.
d) Installing the Receiver
Connect the speed controller output cables to the motor. Observe the operating instructions for the speed controller
or motor used by you.
The chassis has a receiver box to place the receiver. Turn out the four screws of the receiver box lid again and take
it off.
Connect the steering servo and speed controller cables to the correct receiver channel; observe correct polarity in
the receiver. Push the receiver into the receiver box, route the aerial cable outwards and then screw the receiver box
closed again.
Before the receiver is inserted into the receiver box and you screw closed the receiver box, perform a func-
tion test on the vehicle.
For protection from vibration, we recommend wrapping a little foam around the receiver.
The holder for the aerial tubes is on the side of the receiver box. Push the receiver aerial through a suitable aerial
tube (should be enclosed with your remote control system; alternatively available as accessories), and insert the aerial
tube into the holder.
Never shorten the aerial cable and never coil it. This reduces its range!
Attach all cables with cable ties so that they are properly placed and cannot get into the drive. Also ensure that a fan
installed on the speed controller (if present) is not impaired in its function.
40