Gastroback 42716 Bedienungsanleitung Seite 100

Problem Possible Reason
The milk has a The milk is not fresh and/or
stale taste. not cold enough.
The steam wand is not
clean.
With the drip tray The red float (filling level
full, the filling level indicator) sticks to the sup-
indicator does not port.
come up.
All buttons are While switching on the
flashing. appliance, the hot water/
steam switch has been in
horizontal operating posi-
tion.
You attempted to use the
hot water/steam function,
before the water system
reached brewing tempe-
rature.
You attempted to use the
hot water/steam function,
while a brewing cycle is
running.
A severe problem occurred.
The buttons of You attempted to use the
the brewing func- hot water/steam function,
tions (1 cup and while a brewing cycle is
2 cups) and the running.
steam button are
flashing.
The buttons of the Not enough water in the
brewing functions water tank. The WATER
(1 cup and 2 LOW indicator is illuminated.
cups) are flashing
for some seconds
but nothing else
happens.
100
The Solution
Use refrigerated and really fresh milk for texturing (see:
'Texturing Milk').
Clean the steam wand thoroughly (see: 'Cleaning the
Steam Wand').
Pull the filling level indicator upwards and out. Then turn
the a little and push it onto the support again. When
installed in correct orientation, the filling level indicator can
move freely up and down.
The hot water function is available only when the water
system reached the brewing temperature (power button
is illuminated continuously). Turn the hot water/steam
switch back to the vertical position and wait until the
power button will not flash any longer.
The functions of the appliance are available only, when
the water system reached operating temperature (power
button is illuminated continuously). Turn the hot water/
steam switch back to the vertical position and wait until
the power button will not flash any longer.
During brewing, the hot water/steam function is not
available. Turn the hot water/steam switch back to the
vertical position.
Immediately unplug the appliance and get in contact with an
authorized service centre for examination and repair.
During brewing, the hot water/steam function is not
available. Turn the hot water/steam switch back to the
vertical position.
Pour at least 250 ml cold water into the water tank. Then
try again.