Maintenance; Cutting Device (Blade); Repair; Storage - FLORABEST FALHS 40-Li A1 Originalbetriebsanleitung

In particular clean the air vents after every
o
use with a cloth and brush.
Remove stubborn dirt with high pressure air
o
(max. 3 bar).
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.

Maintenance

Q
Before and after each use, check the product
and accessories (or attachments) for wear and
damage. If required, exchange them for new ones
as described in this instruction manual. Observe
the technical requirements (see "Technical data").

Cutting device (blade)

Q
WARNING!
Wear safety gloves when working on
the cutting device and close to it! Use
appropriate tools to remove debris, e. g.
a brush or wooden stick! Never use your
bare hands!
Always use original spare parts for
replacement. Do not attach any other
type of cutting device!
The replacement of the cutting device
should be done by a qualified specialist!
Rework or sharpening blades is not
recommended unless it is done by a
repair service or a similarly qualified
specialist!
1. Switch the product off and remove the battery
pack .
18
2. Keep the cutting device
debris. Remove trimmings.
3. Apply a small amount of suitable lubricant
on the cutting device to retain a good cutting
performance (see Fig. M).
4. Keep the cutting device
worn or damaged cutting device replaced
with a new one of the same type by a
qualified specialist.
clean and free of
16
sharp. Have a
16

Repair

Q
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.

Storage

Q
Switch the product off and remove the battery
o
pack .
18
Clean the product as described (see
o
"Cleaning").
Store the product and its accessories in a
o
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
o
inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
Attach the blade cover
o
We recommend using the original package
o
for storage or covering the product with a
suitable cloth or enclosure to protect it against
dust.
Regularly check the charge level of the
o
battery pack, if it is to be stored for an
extended period. Optimum storage conditions
are cool and dry.

Transportation

Q
Switch the product off and remove the battery
o
pack .
18
Attach the blade cover
o
Attach transportation guards, if applicable.
o
Always carry the product by its handle /
o
handles / gripping surface.
Protect the product from any heavy impact
o
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
o
or falling over.
.
17
.
17
GB 17