Elektro-Automatik PSI 9000 3U Betriebsanleitung Seite 134

PSI 9000 3U Series
IF Level 1 Level 2
Node Address
Baud Rate AUTO
LSS
Manual
IF Level 1 Description
Node Address Adjustment of the GPIB node address (only with option 3W installed) in the range 1...30
Element
Com Timeout
Com Protocols
3.4.3.8 Menu "HMI settings"
These settings refer exclusively to the control panel (HMI).
Element
Language
Backlight Setup
HMI Lock
Key Sound
Alarm Sound
HMI Update
EA Elektro-Automatik GmbH
Page 46
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Description
Selection of the CANopen node address in the range 1...127
Automatic detection of the bus baud rate.(speed)
Automatically sets baud rate and node address
Manual selection of the baud rate that is used by the CANopen interface.
Possible selections: 10 kbps, 20 kbps, 50 kbps, 100 kbps, 125 kbps, 250
kbps, 500 kbps, 800 kbps, 1Mbps (1Mbps = 1 Mbit/s, 10 kbps = 10 kbit/s)
Description
Communication timeout in milliseconds
Default value: 5
Defines the max. time between two subsequent bytes or blocks of a transferred message.
For more information about the timeout refer to the external programming documentation
"Programming ModBus & SCPI".
Enables or disables SCPI or ModBus communication protocols for the device. The
change is immediately effective after submitting it with ENTER button. Only one of both
can be disabled.
Description
Selection of the display language. Currently (date: 05-18-2015) available are:
German, English
Additional languages (up to three can be integrated) can be implemented on demand
and installed into the HMI via update. The default then would be English plus one or two
additional language such as Italian, Spanish etc.
The choice here is whether the backlight remains permanently on or if it should be
switched off when no input via screen or rotary knob is made for 60 s. As soon as input
is made, the backlight returns automatically. Furthermore, the backlight intensity can be
adjusted here.
See "„3.7 Control panel (HMI) lock" on page 57.
Activates or deactivates sounds when touching a touch area in the display. It can usefully
signal that the action has been accepted.
Activates or deactivates the additional acoustic signal of an alarm or user defined event
which has been set to "Action = ALARM". See also „3.6 Alarms and monitoring" on page
55.
With this function the firmware for the control panel can be updated using a USB flash
drive. For details refer to „4.3.1 HMI firmware update" on page 80.
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de