Elektro-Automatik PSI 9000 3U Betriebsanleitung Seite 109

Figure 6 - Control Panel
Overview of the elements of the operating panel
For a detailed description see section „1.9.6. The control panel (HMI)".
Touchscreen display
(1) Used for selection of set values, menus, conditions and display of actual values and status.
The touchscreen can be operated with the fingers or with a stylus.
Rotary knob with push button function
Left knob (turn): adjusting the voltage set value, or setting the parameter values in the menu.
(2) Left knob (push): selection of the decimal position to be changed (cursor) in the current value selection.
Right knob (turn): adjusting the current, power or resistance set value, or setting parameter values in the menu.
Right knob (push): selection of the decimal position to be changed (cursor) in the current value selection.
On/Off Button for DC output
(3)
Used to toggle the DC output between on and off, also used to start a function run. The LEDs "On" and "Off"
indicate the state of the DC output, no matter if the device is manually controlled or remotely
USB-A port
(4)
For the connection of standard USB sticks up to 32GB, formatted to FAT32. Value tables for the function
generator (UI and IU functions) may be loaded or 100 arbitrary function sequences can be loaded or saved.
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
PSI 9000 3U Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
Page 21