Installing The Humidity Temperature Sensor Fts2 (Optional) - Sentiotec CK 41 Montage- Und Gebrauchsanweisung

Instructions for installation and use
3. Connect the two connectors for the bench sensor wire to the two middle
terminals on the connection panel.
4. Place the connection panel crossways in the bench sensor half-shells.
5. Place the two half-shells together and screw them together using the two
Phillips-head screws (9 mm).
6. Check whether the bench sensor has been securely closed.
7. Install the bench sensor on the wall of the sauna room using the two wood
screws enclosed (16 mm). Maintain an clearance of 15 cm to the roof of
the sauna room.

4.5. Installing the humidity temperature sensor FTS2 (optional)

Note Fig. 5 (figures chapter)
The humidity temperature sensor must be installed on the wall of the sauna room
above the rear bench seat. A distance of approx. 15 cm to the roof of the sauna
must be maintained.
To install the humidity temperature sensor, perform the following steps:
1. Lay the two 5-pin bench sensor wires in the wall of the sauna room, leading
them to the humidity temperature sensor installation location and affix the
sensor wires using wire clips.
2. Install the humidity temperature sensor to the wall of the sauna room using
the two wood screws enclosed (16 mm). Maintain an clearance of 15 cm to
the roof of the sauna room.
WORLD OF WELLNESS
p. 14/44