Unold Modell 48816 Bedienungsanleitung Seite 28

10. Place the motor block (1) on the transparent lid (2) and make sure, that the
drive axle (3) fits into the opening of the mixer and that the power contact
with the compressor housing (6) is established.
11. Put the plug into a power socket and press the button ON/OFF to start the
appliance. The display shows „50:00" an. The appliance is ready for opera-
tion.
12. Select the desired freezing time by repeated pressing of the button
ZEITWAHL/Time select in steps of 10 minutes (10, 30, 40 or 50 minutes).
The setting „20 min." is not provided.
13. Press the START/STOP button. After a few seconds, the appliance starts
mixing. The green control light is turning on.
14. Approx. 2 minutes later the freezing is turned on and the red control light
turns on.
15. The display shows alternatingly the remaining preparation time and the
actual temperature of the cooling bowl.
16. During operation, the appliance can be stopped at any time by pressing the
START/STOP button for at least 2 seconds.
17. During operation the freezing time can be extended by pressing the time
select button (Zeitwahl) in steps of 5 minutes up to a max. freezing time of
50 minutes.
18. The appliance turns off automatically after the preselected time. Ten beeps
will sound. The display shows „0:00". The ice cream can be taken out.
19. If the ice cream is still too soft, you can restart the appliance by pressing the
START/STOP button for at least two seconds. Select the desired additional
freezing time with the time select button (Zeitwahl). Then press the START/
STOP button. The appliance will restart for the preselected time and will
then return into the initial mode.
20. If the ice is not taken out within 10 minutes after the beeps, the automatic
freezing function is activated to avoid the ice cream from melting.
21. This function cools the ice cream in steps of 10 minutes for max. one hour.
Then the appliance returns into the starting mode.
22. Switch off and unplug the appliance before taking out the ice cream.
23. To take out the ice cream first remove the motor block and then the trans-
parent lid by turning it counterclockwise.
24. Take the ice cream bowl out and remove the mixer from the ice cream.
25. Fill the ice cream into an appropriate freezing container with lid. Do not use
any sharp tools, but preferably plastic or wood spoons or spatulas.
26. You can now prepare new icecream, just restart at point 1 of this chapter.
28
Copyright UNOLD AG | www.unold.de