Initial Use; Items Supplied And Transport Inspection; Disposal Of The Packaging; Electrical Connection - Parkside PAS 500 C2 Bedienungsanleitung

Initial use

Items supplied and transport inspection

This appliance is delivered with the following components as standard:
▯ Ash vacuum (consisting of container lid with motor and metal container)
▯ Suction hose
▯ Suction pipe
▯ HEPA fi lter (already installed)
▯ Wire-fi lter basket (already installed)
▯ This operating manual
NOTICE
► Check the contents to ensure everything is available and for signs of visible
damage.
► If the contents are not complete or are damaged due to defective packaging
or through transportation, contact the Service Hotline (see Service).

Disposal of the packaging

The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed as per the regionally established regulations.
NOTICE
► If possible, preserve the appliance's original packaging during the warranty
period so that, in the event of a warranty claim, you can pack the appli-
ance ideally for its return.

Electrical connection

For safe and faultless operation of the appliance after making the electrical con-
nection, pay heed to the following instructions:
TAKE NOTE
► Before connecting the appliance compare the connection data (voltage
and frequency) on the rating plate with that of your mains power supply.
This data must tally so as to avoid damage to the appliance.
► Ensure that the mains power cable is not damaged and is not running over
hot surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
PAS 500 C2
GB
41