User Module (Fibrevision-Con) - Guntermann & Drunck FIBREVision Installationsanleitung

User module (FIBREVision-CON)

LED Status
K/M on
blinking
Main on
off
Red. on
off
Sys. on
slow
blinking
blinking
fast
blinking
cyclic
flashing
Trans. on
blinking
Video on
blinking
Bedeutung
Keyboard (PS/2 or USB) was found.
No keyboard (PS/2 or USB) was found.
The main power supply provides the necessary voltage.
The switch for the power supply is turned off or the connection of the
device with the mains supply is not established. Check the connection of
the IEC cable.
The optional power pack is connected and provides the required voltage
(12 Volt).
The optional power pack has not been (properly) connected.
System ready for operation.
Defective internal communication.
Restart the device.
Activated setup mode.
The temperature in the device exceeds the valid values.
The firmware that has been transmitted to the device by the update
wizard is being tranmitted to all components of the system.
This process might take several minutes.
The communication with the computer module has been successfully
established.
The communication with the computer module could not be established.
The incoming image signal at the video input of the computer module is
being properly received by the user module.
No image data are being received at the computer module.
Status displays
G&D FIBREVision · 51