H) Displaying The Maximum/Minimum Values; I) Deleting Maximum/Minimum Values; J) Trend Displays For Temperature And Humidity; K) Warning Of Black Ice Or Frost - Conrad S3318P Bedienungsanleitung

h) Displaying the Maximum/Minimum Values

Briefly press the button „MAX/MIN °C/°F" (4) repeatedly to switch between the following
displays:
• Maximum values („MAX" in the display)
• Minimum values („MIN" in the display)
• Current measured values

If you do not push any button for about 20 seconds, the display mode for maximum/
minimum values is left automatically.
The maximum or minimum values of the indoor/outdoor temperature, indoor/outdoor
humidity and barometric pressure are displayed.

i) Deleting Maximum/Minimum Values

The values are automatically reset at midnight.
The new maximum and minimum values are the measured values at midnight until they are
changed again.

j) Trend Displays for Temperature and Humidity

To the right of every measured value for indoor/outdoor temperature and indoor/outdoor
humidity, a trend display is shown:
Rising

k) Warning of Black Ice or Frost

The icon „ !" (R) flashes at the top of the display when the outdoor sensor measures a
temperature between -4 °C and +1 °C. This is to warn of black ice or freezing wetness.
For temperatures below -4 °C, the icon is displayed permanently (no flashing icon).

The display uses the temperature of the outdoor sensor set to transmission
channel 1. If no outdoor sensor is logged on with transmission channel 1, the outdoor
sensor with the next higher transmission channel is used.
Consistent Dropping
51