Electric Connection - Renkforce GI700BR Bedienungsanleitung

Electric Connection

The electric connection should be made by a specialist.
To avoid short circuits and resulting damage to the moniceiver, the negative pole (earth) of the
vehicle battery must be disconnected during connection.
Only connect the negative pole of the battery when you have completely connected the system
and checked the connections.
You should only use a voltmeter or a diode test lamp for checking the voltage of the on-board
cables, as normal test lamps consume excessive currents and can thus damage the electronics
system of the car.
When laying the cables, make sure that they are not squeezed or scoured on sharp edges. Use
rubber grommets for the feed-though points.
Connection to the speakers must be two-wire each. Insulate any open connection points. Make
sure that the cables are not damaged by sharp edges.
Only use speakers with sufficient load capacity (see "Technical Data").
Observe that all speakers have the correct polarity - that is, that plus and minus marks match.
The connecting cables of the loudspeakers are usually coded: Some speaker manufacturers
indicate the (+) wire by means of an additional colour stripe, others use a corrugated cable for
the (+) terminal and a smooth one for the (-) terminal.
The system was designed for the operation at speaker impedances of at least 4 Ohm. Never
connect speakers with a lower impedance.
For the connection of the cinch sockets for the audio and video connections, only use shielded
cinch wires. Use of any other cables may cause interferences.
Keep the distance of the cables as short as possible.
Do not place the cables near other cables to avoid interferences in the cables.
To avoid distortions or mismatching that could damage the device, cinch connector must only
be connected to devices with the suitable cinch terminals. For this, also observe the connection
information in the section "Technical Data".
54
Operating Instructions

English