Gastroback 40965 Bedienungsanleitung Seite 67

AssemBle the AppliAnce For storAge
(picture F):
A. Place the bowl on the motorblock turning it anticlock-
wise until it is securely locked in position. Do not use
any force. The handle should be facing the front which
is above the control panel (picture A).
B. Fit the spindle onto the drive shaft, in the middle of the
processing bowl (picture B). The long shaft of the spind-
le has to slide over the drive shaft and the end with the
aglet should face upright. If necessary turn the spindle
a little to fit in position. The spindle sticks out of the pro-
cessing bowl for 1 or 2 cm.
c. Fit the universal ›s‹ blade over the spindle and press
firmly into place. Ensure the blade is securely locked
on the spindle. The blade is correct assembled if the
central plastic section faces upwards and flushes with
the wider part of the spindle. The blade is placed a few
millimetres above the bottom of the processing bowl.
D. Fit the variable slicing disc over the spindle. The side
with the blade has to face upwards.
E. Take the lid and place it on top of the processing bowl
according to the instructions ›Operating with the nor-
mal processing bowl‹).
F. Fit the food pusher including the internal pusher into the
feed chute and place the food collector underneath the
processing bowl chute. You can store the small univer-
sal 's' blade inside the food collector.
Always clean the appliance and accessories before storing (see 'care and clea-
ning'). Ensure to store the appliance and accessories (such as the second proces-
sing bowl, mini processing bowl including the lid and the ejector disc), where it is
clean, dry and safe from frost, direct sunlight and inadmissible strain (mechanical
or electric shock, heat, moisture) and where it is out of reach of young children.
Place the appliance on a clean and stable surface, where
it can not fall. Do not place any hard or heavy objects on
the appliance.
The power cord can be stored by pushing it into the back
of the motor base (picture G).
F
g
67