Optical Infrared Interface; Optional Power Pack Operation - VOLTCRAFT 12 23 88 Bedienungsanleitung

- Press the SAVE/CALL button to access the save mode.
- Press F1 until „CALL" appears above the F1 button.
- With the buttons F2 and F3, select the memory slot (0-9) which is supposed to be
called up.
- Press F4 (ENTER) to display the saved measuring curve.
Optical IR interface
The measuring device is equipped with an optical interface. The galvanic separation
of the measuring device from the PC prevents damage to the PC caused by excess
voltage.
The optical interface is located at the top of the measuring device on the front. It ser-
ves to transfer data to a PC for further processing.
- Establish the interface connection with the IR-USB interface cable by connecting
this to a free USB port on your PC.
- Plug the IR-USB interface cable into the optical interface on the top front side of the
measuring device.
- Install the provided demo software or another optionally available measuring soft-
ware to process the measuring data.
- Observe the installation and operating instructions on the CD-ROM.

Optional power pack operation

For longer operation or permanent measuring, the measuring device can be opera-
ted with an optional power pack. The power pack is connected on the left side of the
measuring device. The power pack may only be operated with mains voltage from
220 – 240 V~ 50 Hz.
For safety reasons, only the offered optional power pack may be
used with the DMM. The use of a different power pack may result in
a fatal electric shock.
45