Troubleshooting; Technical Data And Measurement Tolerances - VOLTCRAFT 12 23 88 Bedienungsanleitung

Troubleshooting

In purchasing the DMM, you have acquired a product which has been designed
to the state of the art and is operationally reliable.
Problems and malfunctions may, however, still arise.
For this reason, the following is a description of how you can eliminate possible
malfunctions yourself.
Observe the safety instructions at all times.
Error
The multimeter does not
function.
No measurement of current.
No measuring value change.
Any repair work other than that described above must be carried out by
an approved specialist.
If you have queries about handling the measuring device, our technical
support is available under the following telephone number:
Voltcraft, Lindenweg 15, 92242 Hirschau, tel. no. 0180 / 586 582 723 8
Technical Data and Measuring Tolerances
Technical data
Display
Input resistance
Operating voltage
Current consumption
Operating temperature
Storage temperature
Rel. air humidity
Temp. for guaranteed accuracy
Weight (incl. battery)
Dimensions (HxWxD):
Possible cause
Are the batteries/accumulators flat?
Check the status.
Is the fuse possible for the current measurement
area defective?
Check the fuse
(replacement of fuse)
Are the right measuring sockets selected?
Is the HOLD function activated?
: Graphic dot matrix LCD (160 x 160 pixels)
DMM 4000 counts (display 3999)
: ca. 10MW
: ca. 4.8 6 V (4xAA) accumulator/battery operation
6 V/DC input voltage power pack socket
: max. 130 mA
: 0 to +40°C
: -10 to +50°C
: < 75%, non-condensing from 0°C to 40°C
: +18 to +28°C
: Approximately 540 g
: 200 x 100 x 50 (mm)
49