Setting Partial Light Output/Exposure Correction; Testing Remote Flash Mode - Metz Mecablitz 64 AF-1 digital -Sony Bedienungsanleitung

10.2.5 Setting partial light output/exposure
RMT Ch
REMOTE
SLAVE
2 2
• Press the sensor button on the touch
M-
display for the partial light output/exposu-
Zoom 24
re correction (e.g
for the selection appears.
P
1/1
O
SLAVE
• Press the sensor button on the touch
display for the desired mode of operation
TTL
M
EV / P
O
P
• Press sensor buttons
touch display and set the desired partial
1/4 - 2/3
light output to 1/1, 1/2, 1/8 or 1/256.
1/8
1/8 - 1/3
The partial light output is adopted.
k
p
q
Once the slave flash units have achieved
flash-readiness, the AF measurement flash
flashes.
188
correction
1/1 EV
/ ) . The window
P EV
or .
on the

10.3 Testing remote flash mode

• Place the slave flash units in the desired
positions for the shot.
Use flash unit mounting foot S60 to set up
the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF auxiliary ligh
will blink.
• Press the manual firing button
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
.
sor
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
on the