Metz Mecablitz 64 AF-1 digital -Sony Bedienungsanleitung Seite 177

Setting number of flashes (N)
STROBO • Press the sensor button for the number of
flashes
M-
3.1m
m
35
Zoom
m
5 10
N f(Hz)
P
1/16
O • Press the
N
touch display and select the desired num-
3 ber of flashes.
4
5
p
q
+
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
The setting will take effect immediately.
N
on the touch display.
sensor buttons on the
4
.
Setting the flash frequency (f(Hz))
STROBO
• Press the sensor button on the touch
display for the flash frequency
M-
3.1m
m
35
Zoom
m
4 10
N f(Hz)
P
1/16
f (Hz) O
• Press the
touch display and select the desired fre-
7
quency of flashes.
8
9
p
q
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired frequency of flashes
in the example
The setting will take effect immediately.
STROBO
The valid distance to the set parameters is
shown on the display. The distance value dis-
M-
3.1m
m played can be adjusted to the distance from
35
Zoom
m
the subject by changing the f-stop or the par-
4 8
N f(Hz)
tial light output.
P
The aperture and ISO values are not shown
1/8
on the display in Strobe flash mode!
+
The secondary reflector is not supported in
the Stroboscopic flash mode.
f (Hz)
.
sensor buttons on the
k
8
.
177