Input Menu - Yamaha ysp-1 Bedienungsanleitung

MANUAL SETUP

INPUT MENU

Use to reassign digital input from external components
connected to this unit.
(SET MENU → MANUAL SETUP → INPUT MENU)
3 INPUT MENU
. A)INPUT ASSIGNMENT
B)INPUT MODE
C)INPUT RENAME
[ ]/[ ]:Up/Down
[SELECT]:Enter
INPUT ASSIGNMENT (Input assignment)
You can assign the optical and coaxial digital input jacks
of this unit to other components if this unit's initial
settings do not correspond to your needs. By assigning
other components to the input jacks on this unit, you can
display the name of the connected component in the front
panel display and OSD (see page 20), and operate the
component with the input selector button of the same
name. If you connect a component to this unit's input
jacks and do not assign it, the default component name for
that input jack is displayed in the front panel and OSD
when selected.
• OPTICAL IN(1) assigns components to the TV
OPTICAL IN jack of this unit.
Choices: TV, VCR
OPTICAL IN (1/2)
(. (1);;;;;
(. (1);;;;(
(. (2);;;;;
(. (1);;;;(
[ ]/[ ]:Up/Down
[<]/[>]:Select
• OPTICAL IN(2) assigns components to the AUX
OPTICAL IN jack of this unit.
Choices: AUX, DVD
• COAXIAL IN(3) assigns components to the
COAXIAL IN jack of this unit.
Choices: DVD, AUX
COAXIAL IN (2/2)
. (3);;;;;
. . .
[ ]/[ ]:Up/Down
[<]/[>]:Select
44
TV
TV )
AUX
AUX )
DVD
( DVD )
INPUT MODE (Input mode)
Use this feature to designate the input mode for sources
connected to the DIGITAL INPUT jacks when you turn on
this unit. For information on the types of audio signals that
can be output by this unit, see "Surround Modes and
Recommended Usages" on page 32.
Choices: AUTO, LAST
B)INPUT MODE
)AUTO LAST
[<]/[>]:Select
[SELECT]:Retern
• Select AUTO to allow this unit to automatically detect
the type of input signal and select the appropriate input
mode.
• Select LAST to set this unit to automatically select the
last input mode used for that source. If the type of input
signal is different from the setting, no sounds will be
produced.
INPUT RENAME (Input rename)
Use this feature to change the name of the inputs on the
OSD and front panel display. Press an input selector
button (TV, DVD, VCR, or AUX) to select the component
you want to change the name for, then perform the
following procedure.
C)INPUT RENAME
TV
[<]/[>]:Position
[ ]/[ ]:Chara.
1
Press TEST.
2
Press / to place the _ (underbar) under
the space or the character you want to edit.
The _ (underbar) blinks.
-> TV
TEST
SELECT SELECT