Input Menu - Yamaha YSP-4000 Bedienungsanleitung

MANUAL SETUP
DD/DTS Dynamic Range
(Dynamic range of Dolby Digital and
DTS signals)
Use to select the amount of dynamic range compression.
This setting is effective only when the unit is decoding
Dolby Digital and DTS signals. Dynamic range is the
difference between the smallest sound that can be heard
above the noise of the equipment and the biggest sound
that can be heard without distortion.
Choices: MIN (minimum), STD (standard),
MAX (maximum)
F)DD/DTS Dynamic Range
MIN
p
[ ]/[ ]:Select
[ENTER]:Return
Select to adjust the dynamic range compression.
• Select MIN for listening to sources at low volume
levels.
• Select STD for general use.
• Select MAX for feature films.
TruBass
Use to turn on or off the bass sound enhancer. The SRS
TruBass technology improves bass even without a
subwoofer and provides deeper, richer bass in the presence
of a subwoofer.
Choices: OFF, MID, DEEP
G)TruBass
p
OFF
p
[ ]/[ ]:Select
[ENTER]:Return
Note
TruBass is not available when My Beam (see page 63) or My
Surround (see page 57) is selected as the beam mode.
84
En
p
STD MAX
MID DEEP

INPUT MENU

Use to manually adjust the various parameters related to
the audio and video input.
SET MENU → MANUAL SETUP → INPUT MENU
3)INPUT MENU
.
A)INPUT ASSIGNMENT
B)INPUT MODE
C)INPUT TRIM
D)INPUT RENAME
E)HDMI SET
F)XM ANTENNA LEVEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
Note
"F) XM ANTENNA LEVEL" is for U.S.A. and Canada models
only.
INPUT ASSIGNMENT (Input assignment)
Use to assign the HDMI IN jacks of this unit to other
components if the initial settings of this unit do not
correspond to your needs. By assigning other components
to the HDMI IN jacks of this unit, you can display the
names of the connected components in the front panel
display and OSD and operate the components with the
input selector buttons of the same name. If you connect a
component to one of the HDMI IN jacks of this unit and
do not assign a name to it, the default component name for
HDMI IN jack is displayed in the front panel and OSD
when selected.
• Select HDMI1 to assign a component to the HDMI
AUX 1 IN jack of this unit.
Choices: TV/STB, AUX1
• Select HDMI2 to assign a component to the HDMI
DVD IN jack of this unit.
Choices: DVD, AUX2
• Select Line1 to assign a component to the STB
COMPONENT VIDEO IN jacks of this unit.
Choices: TV/STB, AUX1
• Select Line2 to assign a component to the DVD/AUX 2
COMPONENT VIDEO IN jacks of this unit.
Choices: DVD, AUX2
• Select Line3 to assign a component to the AUX 1
VIDEO IN jack of this unit.
Choices: DVD, AUX2