Operation; Table Saw Level Cutting; Table Saw Angle Cutting - Holzmann TK 305 Betriebsanleitung

14.2

Operation

Please install the dust bag when you use this machine.
Then connect the power.

14.2.1 Table saw level cutting

Install all accessories and connect the power. By pressing the ON/OFF-button the machine will be
start.
1. Select and cut objects thickness cannot
overstep 55mm of the table mode cutting
size.
2. According to your actual required of cutting
length to adjust the "table orientation plate
groupware" location.
a. Put the cutting objects on the table
working face.
b. Select the cutting data of yours
requirement.
c. When the cutting size was determined,
Please position the "Cutting & position size
knob".
3. Hold the "Safety plush stick" and plush the
cutting object forward until it to sever.

14.2.2 Table saw angle cutting

1. Install and position the "table orientation plate
groupware".
2. According to your actual required of cutting
angle to adjust the "table orientation plate
groupware" location.
a. Put the cutting objects on the table working
face.
b. Select the cutting angle data:
Select and cut objects angle between: -
30°～90°～30°. Then screw up the "cutting &
position angle knob" with your hand.
3. Hold the "Safety plush stick" and push the
cutting object forward until it to sever.
ON/OFF SWITCH
The "ON/OFF switch" control the "Table Saw cutting mode" ON/OFF positions. The "ON/OFF
SWITCH" buttons are located on the right side of the "mitre handle". Two kinds colour switch
button: The green button represents ON. Press the "ON" button down when you connect up the
power, the machine will be enter to working position now. The red button represents "OFF". Press
the "OFF" button down when you connect up the power, the machine will be stop working.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T I C E
TISCH UND KAPPSÄGE / COMPOUND TABLE/MITRE SAW TK 305
OPERATION
Seite 35