Remaining Risk Factors - Holzmann TK 305 Betriebsanleitung


 The plug of an electrical tool must strictly correspond to the socket. Do not use
any adapters together with earthed electric tools
 Each time you work with an electrically operated machine, caution is advised!
There is a risk of electric shock, fire, cutting injury;
 Protect the machine from dampness (causing a short circuit)
 Use power tools and machines never in the vicinity of flammable liquids and
gases (danger of explosion)
 Check the cable regularly for damage
 When working with the machine outdoors, use extension cables suitable for
outdoor use
 Do not use the cable to carry the machine or to fix the work piece
 Protect the cable from heat, oil and sharp edges

Avoid body contact with earthed
 Before starting the machine remove any adjusting wrenches and crewdrivers
 Use a clip or clamping jaws to secure the workpiece
 If devices are provided for the connection of dust extraction and collection
facilities, ensure these are connected and properly used.
 Rotating parts can cause severe cut injuries
 Keep the blades sharp and clean, so they get stuck less often and are easier to
guide
 Keep any machine that is not being used out of reach of children
12.3

Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
Despite of correct and proper use and maintenance there remain some residual risk factors:
 Hazard of injury or machine damage due to undetected machine defect
To minimize this risk, check the machine prior to every operation for loose screws and
connections. Check the motor noise, the spindle, the drill chuck, etc. for eventual damage.
Damaged parts have to be replaced immediately, no operation of the machine in the
meantime!
 Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric installation,
and let it check periodically by a trained electrician.
 Danger due to unintended machine start-up
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
TISCH UND KAPPSÄGE / COMPOUND TABLE/MITRE SAW TK 305
SAFETY
Seite 31