Maintenance; Maintenance Plan; Install The Dust Bag - Holzmann TK 305 Betriebsanleitung

15

MAINTENANCE

The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1

Maintenance plan

After each workshift:
 Apply a thin layer of oil on sliding parts
 Remove dust and wood chips from the device
15.2

Install the dust bag

1. Squeeze the spring with your thumb and
forefinger.
2. Aligned dust hole, then insert it to the
dust hole annular groove; Release your
fingers.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Don't clean or do maintenance on the machine while it is still connected
to the power supply:
Damages to machine and injuries might occur due to unintended
switching on of the machine!
Therefore: Switch the machine off and disconnect it from the power
supply be-fore any maintenance works or cleaning is carried out
A T T E N T I O N
N O T I C E
TISCH UND KAPPSÄGE / COMPOUND TABLE/MITRE SAW TK 305
MAINTENANCE
Seite 40