System; Beeper; Passcodes - Siemens SIREC D Handbuch

4.11 SYSTEM

The System selection, in the Program Menu, allows
you control the Beeper and to set the passcodes. To
modify these parameters, select the PROG menu
and use the UP (↑) or DOWN (↓) Arrow Keys to
highlight "System" and press ENTER.

4.11.1 Beeper.

This menu item allows you to
turn the Beeper on or off. If on, the beeper provides
audible feedback to key presses, indicates errors
and beeps on alarm condition.
1. Use the UP (↑) or DOWN (↓) Arrow Keys to
highlight "Beeper" and press ENTER. The display
shows "Beeper=No*" or "Beeper=YES*" depend-
ing on the current state of the beeper.
2. Press YES to turn it on, or NO to turn it off and
press ENTER to return to the System Menu.

4.11.2 Passcodes.

to protect the setup from unauthorized change.
Once set, the passcode must be entered to gain
access to either the PROGram menu or the
FUNCtion menu. Separate Pass codes can be set
for each. Note that if a pass code is forgotten, you
will not be able to change the configuration of the
unit. The only way to change or delete a pass code
is to know the original passcode. Treat passcodes
with respect.
1. To enter a pass code (or change a pass code),
use the UP (↑) or DOWN (↓) Arrow Keys to high-
light "Passcodes" from the System menu and
press ENTER. There are two options:
•
Function - Enter a pass code to protect the
FUNCtion menu
•
Program - Enter a pass code to protect the
PROGram menu and Hidden menu.
Siemens AG C79000-G7374-C211-01
SIREC D Manual
Passcodes allows you
The two pass codes may be the same, or differ-
ent, or may be disabled. The pass code may be 1
to 6 numeric characters. Entering a pass code of
000000 or all spaces, is equivalent to setting NO
Pass code. The pass code is displayed as you
enter it so that you may check it for accuracy.
Once entered, you will not be asked to verify it,
but you may re-enter it.
1. Use the UP (↑) or DOWN (↓) Arrow Keys to
select which passcode you want to enter and
press the ENTER button. The display will show a
blank Pass code. If you press ENTER at this
stage you will clear the pass code.
2. Use the numeric keypad to enter a pass code
from 1 to 6 characters in length. WRITE THE
PASS CODE DOWN
SOMEPLACE SAFE. Press the ENTER key to
accept the pass code and return to the Passcode
menu. Repeat the above for the other menu op-
tion.
NOTE
Once a pass code is entered, you will be
prompted for it the next time you try to enter
the main menu. If you do not enter it cor-
rectly, you will be denied access to the
menu.
Programming
AND KEEP IT
4-57