Smart Init - Siemens SIREC D Handbuch

Operation
NOTE
It is recommended that you save a configu-
ration file to disk, from the Companion soft-
ware program or from the Recorder, to en-
sure that a copy of the configuration is
available. If a failure should occur in the
Recorder configuration, a new configuration
file can be down-loaded from the disk.
D. INITIALIZE DATABASE - Three forms of in-
itialization may be performed on the Profile data-
base, Smart Init, Full Init., and Erase Config. You
will not typically see these options unless the unit is
being powered up for the first time, or the unit finds
an error in the database. These conditions can be
manually invoked using the Hidden menu.
1. SMART INIT - Smart Initialization verifies that
each Profile database block has a correct check-
sum and (if incorrect) each parameter in the cor-
rupt block(s) is verified to be within allowable
boundaries. Only those parameters in corrupt
blocks found to be outside these boundaries are
changed. Bad parameters are always replaced
with pre-defined defaults.
2. FULL INIT - If you answer NO to "Smart init?",
a choice is presented to force the recorder to do
a "Full init?". Full initialization will completely
clear all user-defined parameters, setting them to
pre-defined defaults.
3. Erase Config - This option is used on first time
power up and will not normally be seen by you
unless the database has been corrupted or this
option is called from the System menu. This op-
tion will clear all variables to zero, and should be
used to clear memory before programming for
the first time, or after an upgrade of the software.
4. INIT DEFAULTS - The listing below gives the
default parameters that are used by both Smart
and Full initialization:
3-2
Display Block
Power-up Display Mode=
Display Rate=
Time Format=
Language=
Scan Block
Alarm Contact Outputs=
Alarm Checks=
TCBO Test Interval=
Serial Port
Serial port=
Chart Scales Block
For Each Scale...
Scale Type=
Origin=
Decimal Fix=
Scale=
Engineering Units=
Active Scaleset=
Bargraph/Pens Block
Pen Assignments=
Bar Assignments=
Digital Assignments=
Display Chart Speed Block
Unit Tag=
Chart Speed=
Lo Chart Speed=
Hi Chart Speed=
Passcode Protection Block
Program Key Passcode=
Function Key Passcode=
Siemens AG C79000-G7374-C211-01
Unit Tag
1 second
American
English
Open on Clear, No Reflash, Fail-
safe off, Open on ACK,
Enabled
300 Seconds (5 minutes)
Set to Modbus RTU, 9600, 8bits,
parity off, 2 stops
Linear
Left
3 places
Low= 0.0 Mid= 50.0 High= 100.0
Set to all spaces (cleared)
Set to scaleset 1
Set to: Pen 1 = point 1
Pen 2 = point 2
Pen 3 = point 3
Pen 4 = point 4
Pen 5 = point 5
Pen 6 = point 6
Set to: Bar 1 = point 1
Bar 2 = point 2
Bar 3 = point 3
Bar 4 = point 4
Bar 5 = point 5
Bar 6 = point 6
Set to: Digital 1 = point 1
Digital 2 = point 2
Digital 3 = point 3
Digital 4 = point 4
Digital 5 = point 5
Digital 6 = point 6
Set to "Unit Tag"
Standard; High Speed; No
AutoSpeed change on alarm
60"/hr
60"/hr
Set to None
Set to None
SIREC D Manual