Point Options - Siemens SIREC D Handbuch

Programming
B. Point Options -
sen, if the point is a new point to program, the point
can be setup from scratch, copied from another
point already setup, or restored if the point had been
setup previously and then deleted. If the point cho-
sen has already been setup, the point parameters
may be modified, or the point may be deleted. Refer
to the following steps and to Figure 4-11 to program
a point.
1. At the Display Menu, press the Menu Button on
the Display Button Bar to bring up the Command
Button Bar.
2. Press the PROGram Button on the Command
Button Bar. The Program Menu box will appear.3.
Use the Up (↑) or Down (↓) Arrow Keys, on the
Button Bar, to scroll to "Points" and press the
ENTER Button. The Points/Constants menu box
will appear.
1 0 37 3 6 M A
4-20
After a point number is cho-
0 4 /1 6 /97 4 :5 9 :2 9
Figure 4-11 Point Setup Flow Chart
4. Use the Up (↑) or Down (↓) Arrow Keys, on the
Button Bar, to scroll to "Prog point" and press the
ENTER Button. The Point Number pop-up dialog
box will appear.
5. The display reads "point? x". Use the numeric
keypad (1 - 9, A - C) to enter the point to be pro-
grammed or modified. Press ENTER to accept the
displayed point number and the display reads one
of the followings menu items:
•
Setup pt
•
Copy pt
•
Restore pt
or, if the point has already been setup ..
•
Modify pt
•
Delete pt
Siemens AG C79000-G7374-C211-01
EN T ER
SIREC D Manual