Setup A Point By Copying; Setup A Point By Restoring; Modify An Existing Point; Delete An Existing Point - Siemens SIREC D Handbuch

C. Setup a Point by Copying -
steps guide you:
1. At the "point? X" display, use the Numeric Key-
pad to enter the point number desired and press
ENTER. The Point Option Dialog Box will appear.
2. Use the UP (↑) or DOWN (↓) Arrow Key to
highlight the "Copy pt" menu option and press
ENTER. The display will read "from pt? X".
3. Use the UP (↑) DOWN (↓) Arrow Keys to select
the desired point number, 1 - 9 or A - C, from
which to copy the parameters. When the point
number desired to copy from is displayed, press
ENTER. The display reads one of the menu items
in the Point Type Menu. You may continue pro-
gramming to change the point parameters as
needed.
D. Setup a Point by Restoring -
following steps guide you:
1. At the "point? X" display, use the numeric keypad
to enter the point number desired to restore and
press ENTER. The Point Option Dialog Box will
appear.
2. Use the UP (↑) or DOWN (↓) Arrow Keys to
highlight "Restore pt" menu option and press
ENTER. You may continue programming to
change the point parameters as needed.
To restore a point, that point must have been
previously programmed and still be in the
system memory. If the point was not previ-
ously programmed you will get a "PT
NEVER SET" message.
E. Modify an Existing Point -
steps guide you:
1. At the "point? X" display, use the numeric key-
pad to enter the point number desired to modify
and press ENTER. The Point Option Dialog Box
will appear.
2. Use the UP (↑) or DOWN (↓) Arrow Keys to
highlight "Modify pt x" and press ENTER. You
may continue programming to change the
point/parameters as needed.
Siemens AG C79000-G7374-C211-01
SIREC D Manual
The following
NOTE
The following
F. Delete an Existing Point -
steps guide you:
1. At the "point? X" display, use the numeric key-
pad to enter the point number desired to modify
and press ENTER. The Point Option Dialog Box
will appear.
2. Use the UP (↑) or DOWN (↓) Arrow Keys to
highlight "Delete pt" and press ENTER. The dis-
play will read "confirm del?".
3. Press ENTER or YES to delete the point. Press
NO to exit the Delete Point Menu without deleting
the point.
G. Setup an Unprogrammed Point -
Set up an unprogrammed point, perform the
following:
1. Use the UP (↑) or DOWN (↓) Arrow Keys to
The
highlight "Setup pt" and press ENTER. The dis-
play reads the Point Type Menu as follows:
• Linear
• Ind sqrt
• Log linear
• T/c
• Rtd
• Calculated
• Conditional
• External
2. Refer to the appropriate following Options to
continue programming points.
Programming
The following
To
4-21