Safety Measures - Unitest Hexagon 120 Bedienungsanleitung

3.0 Safety Measures

The respective accident prevention regulations estab-
lished by the professional associations for electrical
systems and equipment must be strictly met at all
times.
The respective accident prevention regulations estab-
lished by the professional associations are to be strict-
ly enforced at all times regarding body protection in
the event of danger of burns.
In order to avoid electrical shock, the valid safety and
VDE regulations regarding excessive contact voltages
must receive utmost attention, when working with
voltages exceeding 120V (60V) DC or 50V (25V)rms
AC. The values in brackets are valid forlimited ranges
(as for example medicine and agriculture).
Measurements in dangerous proximity of electrical in-
stallations are only to be executed when instructed by
a responsible electrical specialist, and never alone.
If the operator's safety is no longer ensured, the instru-
ment is to be put out of service and protected against
use. The safety is no longer insured, if the instrument:
- shows obvious damage
- does not carry out the desired measurements
- has been stored for too long under unfavourable
conditions
- has been subjected to mechanical stress during
transport.
The instrument may only be used within the operating
ranges as specified in the technical data section.
Safety Measures
31