Battery Replacement - Unitest Hexagon 120 Bedienungsanleitung

Battery Replacement

7.3 Battery Replacement
Prior to storage battery replacement, disconnect the
instrument from any connected test leads.
Only use accumulators as described in the technical
data section!
Please consider your environment when you dispose
of your one-way batteries or accumulators. They be-
long in a rubbish dump for hazardous waste. In most
cases, the batteries can be returned to their point of
sale.
Please, comply with the respective valid regulation re-
garding the return, recycling and disposal of used bat-
teries and accumulators..
If an instrument is not used over an extended time pe-
riod, the accumulators or batteries must be removed.
Should the instrument be contaminated by leaking bat-
tery cells, the instrument has to be returned for clean-
ing and inspection to the factory.
Switch of the instrument and disconnect from all meas-
urement circuits and test leads.
Remove the protective rubber holster and loosen the
screws on the instrument rear.
Lift the battery case cover
Replace the discharged batteries
Insert new batteries and ensure there is correct polarity.
Replace the battery case cover and retighten the screws.
Replace the protective rubber holster.
Battery: 2 x 1,5 V, IEC LR03
46