Disposal; 10 Ce Conformity; 11 Troubleshooting - Profitec Pro 600 Bedienungsanleitung

9

DISPOSAL

This product complies with EU Directive 2012/19/EU and is registered according to WEEE (Waste Electrical
and Electronic Equipment).

10 CE CONFORMITY

Conformity
The product complies with the following EU Directives:
Machine: 2006/42/EC
Low Voltage: 2014/35/EU
EMC: 2014/30/EU
PED: 2014/68/EU
EN-Directives: EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75,
EN 55014, EN 61000-3, EN 61000-4, ENV 50141, EN 55104

11 TROUBLESHOOTING

Problem
The machine is switched on, but
the machine does not work.
The machine is switched on, but
the machine does not work.
Portafilter/ brew group is
dripping.
"CLn" is shown on the display.
There is a dot on the display.
No Steam
The Machine is cold qickly
Bedienungsanleitung / Instruction manual Profitec PRO 600 - I
WEEE Reg.-Nr.: DE 97592029
Possible Cause
Water has been refilled, PID-
display is off
PID-display is turned off: There is
not enough water in the fresh
water tank
The water tank is not fixed
properly.
Portafilter is not fixed properly.
Group gasket is broken.
The cleaning mode is
programmed
The display is switched off.
The Steamboiler ist switches off
The Eco-Mode is ON
Troubleshooting
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet point
on the upper part of the floater
side.
Refill water.
Fix the water tank properly.
Fix the portafilter properly.
Change group gasket and
shower screen.
Clean the brew group. After
having operated the brew lever
10 times, the "CLn" will
disappear.
Press
Go in to the PID-Menu and set
the steamboiler ON
Turn the Eco-Mode in the PID-
Menu OFF ore set the switch off
countdown longer
31
ENGLISH
+
to turn it on.