Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
SOP 1
SOP 2
Figure 3
Please make sure that the solvent bushings and the blind fittings
are tight. If they are not, the specifications of the LPG cannot be
guaranteed.
Set the desired low-pressure gradient in the pump's setup menu
according to SOP 1and SOP 2.
Selecting a Gradient Mode
This SOP applies to the Smartline Pump 1000 Firmware Revision 1.0X.
Use this SOP for selecting a gradient mode.
1.
Select „GRADIENT MODE" in the SETUP Menu.
2.
Select the desired mode of operation.
3.
If you select either high or low pressure gradient (i. e. HPG or LPG)
you need to specify the channels of used solvents:
Low Pressure Gradient: Choose valves A to D
High Pressure Gradient: Choose pump names HPG A to HPG D
4.
Move to the second line by pressing
(for LPG mode) or pumps actually present (for HPG mode) on the
corresponding positions by pressing
apply for programs and define the number and names of solvents
used in any gradient.
Selection of operation mode:
This SOP applies to the Smartline Pump 1000 Firmware Revision 1.0X.
1.
Return to page GRADIENT MODE by pressing
2.
Press
and then
until LPG appears.
3.
Use
to position cursor in the second line.
4.
Select ON or -- (off) at positions A, B, C and D for the solvent
channels in either mode you wish to use. The number of ONs
selected refers to all programs in the pumps memory.
5.
At any position you can use
6.
Position cursor on next position, e. g. B and select ON .
7.
Select three times
8.
The display should appear as shown in Figure 3.
9.
Leave this menu page with
Load
Edit Prog
Prog
Clear 0
GRADIENT MODE:
Link
View
Hold 0
Run 1
Example for a gradient setup with solvents A and B in all programs
The LPG block and the connection tubes should be rinsed with the
provided solvent and filled before they are used.
When the pump is turned off, the LPG block's valves are closed. To
rinse the LPG block, set the flow rate to 0 ml/min and set the
pertinent mixture portion of the solvent for the respective valve to
Low Pressure Gradient (LPG) Block
and choose valves A to D
or
to scroll through the gradient mode options
or
to select ON.
to position cursor at the rhombus.
to return to the main menu.
Flow
Pressure
Events
[ml/min]
[0.1 Mpa]
off 0
LPG
ON
ON
Time
%A
%B
[min]
. This selection will
.
on 1
2
Setup
GLP
--
--
%C
%D
Werbung
Inhaltsverzeichnis
Fehlerbehebung
