Installation; Mounting The Sensor; Retrofit Kit For Inpro 6870 I / Inpro 6960 I / Inpro 6970 I - Mettler Toledo InPro 6000 Bedienungsanleitung

InPro 6000 Series Optical O
4

Installation

The "Plug & Measure"-concept allows the user to mea-
sure oxygen values immediately after installation.
– The sensor is recognized automatically and all
relevant data are sent to the transmitter, the oxygen
values are displayed.
The sensor is factory calibrated. The factory cali-
bration data are stored in the sensor and do not
need to be entered by the user.
4.1

Mounting the sensor

a
Important! Remove the protection cap before mount ing
the sensor.
Mounting the sensor in a housing
Please refer to the instruction manual of your housing
explaining on how to mount the sensor in place.
Mounting the sensor directly on a pipe or a vessel
The 12 mm sensors can be mounted directly through
a socket with inside thread Pg 13.5 and securely tight-
ened via the Pg 13.5 threaded sleeve. The sensor can
be mounted in any orientation.
a
Attention! Do NOT turn the sensor anti-clockwise
when installing or removing it from a housing / pro-
cess connection. Use the turning nut to secure or un-
secure the sensor from the housing / process connec-
tion and, if required, turn the sensor clockwise.
Turning the sensor anti-clockwise can result in loos-
ening or removal of the sensor tip allowing ingress of
fluid into the sensor body.
4.1.1 Retrofit kit for
InPro 6870 i / InPro 6960 i / InPro 6970 i
For protection of the sensor head against environmen-
tal influences (temperature, humidity) the use of the
retrofit kit (52 403 811) is recommended. For instal-
lation, see the manual of the retrofit kit.
Retrofit kit
© 01/ 2016 Mettler-Toledo GmbH InPro 6000 optical O
Printed in Switzerland
Sensors 12 mm
2
15
sensors
2
52 206 256