Replacing The Battery - PeakTech 1660 Bedienungsanleitung

6. Then install the PC software from the main folder of the CD
with the file Setup.exe.
7. Turn on the meter and press the USB button.
8. Start the software "P1660".

8. Replacing the battery

WARNING!
To avoid electrical shock, disconnect the test leads and any
input signals before replacing the battery. Replace only with
same type of battery.
This meter is powered by a NEDA type 1604 or equivalent 9 V-
battery. When the meter displays the battery symbol the battery
must be replaced to maintain proper operation. Use the following
procedure to replacing the battery.
1. Disconnect test leads from any live source, turn the rotary
switch to OFF and remove the test leads from the input
terminals.
2. The battery cover is secured to the bottom case by a screw.
Using a Philips-head screwdriver, remove the screw from
the battery cover and remove the battery cover.
3. Remove the battery and replace with a new equivalent 9 V-
battery.
4. Replace the battery cover and reinstall the screw.
Statutory
Regulations
The delivery of many devices includes batteries, which for
example serve to operate the remote control. There also could
be batteries or accumulators built into the device itself. In
connection with the sale of these batteries or accumulators, we
are obliged under the Battery Regulations to notify our
customers of the following:
Notification about
-57-
the Battery