Replacing The Fuses - PeakTech 1040 Bedienungsanleitung

7. Replacing the fuses

Warning:
To avoid electric shock, disconnect the test leads from any source of
voltage before removing the back cover or the battery/fuse door.
1. Unscrew the screw for the battery compartment to open the
battery compartment.
3. Remove the blown fuse from the fuse holder.
4. Insert the new fuse into the fuse holder - appropriate to the value
and the dimensions of the original fuse. Make sure that the fuse
is centred in the holder.
5. After replacing the appropriate backup, attach the battery cover
back to the device and secure it
Warning:
To avoid electric shock, do not operate your meter until the back
cover and the battery door is in place and fastened securely
Note:
If your meter does not work properly, check the fuses and battery to
make sure that they are still good and properly inserted.
200mA / 600V AC/DC 6,3 x 32mm (P 1040)
500mA / 600V AC/DC 6,3 x 32mm (P 1041)
0 A / 600V AC/DC 6,3 x 32 mm
72