Special Safety Advice For Polishing; Special Safety Advice For Working With Wire Brushes; Device-Specific Safety Instructions For Small Drill Pmgs 12 B2 And Mains Adapter-Pmgs 12 B2; Operation - Parkside PMGS 12 B2 Bedienungsanleitung

General safety advice for electrical power tools / Operation
Special safety
Q
advice for polishing
D o not use the polishing bonnet if it
has any loose parts, in particular the
fastening cords. Tuck the fastening cords
away or trim them. Loose fastening cords rotat-
ing with the attachment could catch your fingers
or become trapped in the workpiece.
Special safety advice for
Q
working with wire brushes
a) Bear in mind that wire brushes lose
pieces of wire during normal use. Do
not overload the wires by applying too
much pressure. Flying pieces of wire can very
easily penetrate thin clothing and / or skin.
b) Use a guard, if recommended, but make
sure that the wire brush does not come
into contact with the guard. The diameters
of disc brushes and cup brushes can increase
due to contact pressure and centripetal forces.
Device-specific safety instructions
Q
for small drill PMGS 12 B2 and
mains adapter-PMGS 12 B2-1
W hen you use the drill / grinder wear
the following protective equipment:
safety glasses and protective gloves.
For indoor use only!
CAUTION! The tool continues to rotate
after it has been switched off! Avoid
contact with rapidly rotating drill / grinder com-
ponents.
workpiece. Use clamps or a vice to grip the
workpiece firmly. This is much safer than holding
it in your hand.
self by placing your hands near or in
front of the device or the workpiece
surface. A slip can result in injury.
36 GB
Securely support the
Never support your-
A void contact with moving sanding or
grinding tools.
D ANGER OF FIRE FROM FLyING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
D o not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
A void abrading paints containing lead
or other substances hazardous to health.
D o not machine materials containing
asbestos. Asbestos is a known carcinogen.
D o not machine moist materials or
damp surfaces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
and allow it to come to a standstill be-
fore you put it down.
clean, dry and free of oil or grease.
C hildren or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.

Operation

Q
N ever use the device for a purpose
for which it was not intended or with
non-original parts / accessories. The use
of tools or accessories other than those recom-
DUST HAZARD! Any
NOXIOUS FUMES!
Switch the device off
Always keep the device