Inserting Or Replacing A Tool / Collet; Switching On And Off / Setting The Speed Range; Advice On Working With Materials / Tools / Speed Ranges - Parkside PMGS 12 B2 Bedienungsanleitung

mended in the operating instructions could lead
to you suffering an injury.
Inserting or replacing
Q
a tool / collet
P ress the spindle lock
R otate the clamping nut
engages.
L oosen the clamping nut
tion key .
23
I f a tool is already inserted, remove it.
F irst insert the tool you wish to use though the
clamping nut before you insert it into the
5
collet suitable for the tool shaft.
18
P ress the spindle lock
I nsert the collet
18
tighten the clamping nut
the combination key
Using the Insertion tool with mandrel
NOTE: Use the screwdriver end of the combi-
nation key to release or tighten the screw of
23
the mandrels .
13
I nsert the mandrel
13
described.
W ith the aid of the combination wrench
unscrew the screw from the mandrel
P lace the insertion tool you wish to have onto
the screw between the two washers.
W ith the aid of the combination wrench
tighten the screw on the mandrel
Switching on and off /
Q
Setting the speed range
Switching on / Setting the speed range:
C onnect the plug
4
by inserting it into the plug-in device
for such purposes (see Fig. C).
C onnect the device to the power supply by
inserting the mains plug into the socket.
Press down the ON / OFF switch
move it in direction of the rotational speed con-
trol . Then set the rotational speed control to
1
a position between "5" and "20".
and keep it pressed.
7
until the lock
5
with the combina-
5
and keep it pressed.
7
into the threaded insert and
on the thread using
5
.
23
into the electrical tool as
23
.
13
23
.
13
to the power supply unit
provided
8
and then
2
Switching off:
Set the rotational speed control
"5". Press down the ON / OFF switch
then move it in direction of the cable.
Advice on working with
Q
materials / Tools / Speed ranges
U se the highest speed when working on steel
or iron with the milling bits
U se a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
U se the low speed range for working on plastics
and low-melting point materials.
U se high speeds on wood.
U se the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
: recommendatory only. Learn by practical experience
13
which tools and settings are the best for the materi-
als you work with.
Setting the appropriate speed:
Numeral on the
,
rotational speed
control
1
5
,
8
12
16
20
Examples of appropriate tool selection
Function:
10
Function
Drilling
Milling
Operation
1
.
20
Material to be
worked on
Plastics and low melting
point materials
Stone, Ceramics
Softwood, metal
Hardwood
Steel
Accessory Application
HSS drill Drilling wood
12
Milling bits Various tasks, e.g.
hollowing out,
20
gouging, shaping,
grooving or slotting
to position
and
2
GB 37