Quartz Watches; General Information - Baume And Mercier Clifton Bedienungsanleitung

CHRONOGRAPH WITH COMPLETE
CALENDAR AND MOON PHASE
27
To use the Chronograph function, refer to the preceding
paragraph Simple Chronograph.
Wa rning: To prevent damage to the movement, it is
extremely important that you do not make any adjustments
(day, date, month and moon phase) between 9.30 p.m. and
4 a.m.
To adjust your watch, be careful to ensure it is fully wound
and then respect the following steps in this specific order:
Initial pre-setting stage
1. Pull the crown out to Position 3, which will stop the
seconds hand (C).
2. Turn the crown to advance the hands (A,B) clockwise
until the date hand (E) and the day (K) change (when the
watch indicates midnight).
3. Continue turning the crown to position the hands at
6 a.m.
4. Push the crown back to Position 2.
Setting the date and month
5. Turn the crown counter-clockwise to advance the date
(E) until the month (M) and the date (E) are positioned
as desired.
Setting the moon
6. Turn the crown (still in Position 2) clockwise to turn the
moon-phase disc until the full moon appears in the center
of the aperture.
12 |
7. Continue to turn the crown so as to make as many jumps
as the number of days that have elapsed since the last full
moon (consult a calendar).
To know the dates of the full moon and set your watch,
please visit our www.baume-et-mercier.com website and
consult the page corresponding to your model.
Setting the day of the week
8. Press the corrector button (C1) to advance the day (K) to
the desired day. To do this, use the small tool provided
in the packaging.
Setting the time
9. Pull the crown to Position 3.
10. Turn the crown to advance the hands (A,B) clockwise
and position them at the desired time.
11. At the hourly time signal (reference clock, radio, etc.),
reset the crown in to Position 1.
Note: the hand (N) provides 24-hour time reading, serving
for example to tell the difference between 8 a.m. and 8 p.m.
III. QUARTZ WATCHES
A. GENERAL INFORMATION
A quartz watch is powered by a battery which generally lasts
between 2 to 6 years depending on the model.
The majority of our quartz watches, having a central seconds
hand, come equipped with a system to indicate a low battery
(EOL – End of Life). Approximately two weeks before the
battery will stop, the central seconds hand will begin to jump
every four seconds as a signal to the wearer that the battery
must be changed.
Batteries must be changed by an authorized Baume & Mercier
retailer or After-Sales Service Center to insure that the
battery and any other maintenance meet Baume & Mercier's
standards. Respecting this requirement is imperative in
connection with the International Guarantee.
COLLECTION AND TREATMENT OF END OF
LIFE QUARTZ WATCHES*
Quartz watches contain a battery as well as
other electronic components. When your watch
is serviced, your authorized Baume & Mercier
retailer or A fter-Sales Service Center will
take care of storing and disposing of these
components in compliance with current laws.
This symbol indicates that this product should
not be disposed with household waste. It has
to be returned to a local authorized collection
system. By following this procedure you will contribute
to the protection of the environment and human health.
The recycling of the materials will help to conserve natural
resources.
*Valid in EU member states and in any countries with
corresponding legislation.
Note: Since 2011, all batteries used in Baume & Mercier
watches are mercury-free.
PRECISION OF A QUARTZ WATCH
Quartz watches are extremely precise. This is due to the high
frequency of their vibrations (32 kHz). Their precision (fast
or slow) deviates by approximately 1 minute per year.
| 13