Cleaning The Filter Element - Stihl SE 122 Gebrauchsanleitung

English
N
Switch off the vauum cleaner and
the electric power tool that is to be
connected prior to connection to the
machine socket (1).
N
The machine is switched on and off
or to automatic mode by means of
the switch (2). The suction power is
adjusted manually by turning the
switch.
Switch positions
Switch position 0 – Vacuum cleaner is
switched off, the machine socket cannot
be used.
Switch position I – Vacuum cleaner is
switched on, the machine socket cannot
be used.
Switch position auto – The power tool
connected to the machine socket
switches the vacuum cleaner on and off
via the automatic function.
The connected power tool must be
switched off before setting the switch to
the "auto" position.
The motor runs on for a few seconds
after switching off in order to empty the
suction hose.
Vacuuming dry materials
Flammable materials must not
be vacuumed.
Always make sure that the filter bag has
been fitted in the container before
vacuuming dry materials. The
vacuumed material can then be
disposed of without difficulty. Dry
materials can also be vacuumed without
filter bag.
22
Vacuuming liquids
Flammable liquids must not be
vacuumed.
Always remove the filter bag and check
operation of the float before vacuuming
liquids. The float switches off the air
stream when the container is full. If the
machine is exclusively used for wet-
vacuuming, the filter element should be
replaced by a special insert (special
accessory).
The filter element is damp after
vacuuming liquids. The filter element is
likely to clog up more quickly if dry
material is vacuumed while it is still
damp. For this reason, the filter element
should be dried or replaced by a dry filter
element before vacuuming dry
materials.
After use
N
Unplug the power plug from the
socket.
N
Roll up the power cord and hang it
over the handle.
N
Empty the container and clean the
machine.
After vacuuming liquids:
N
Remove the upper part of the
vacuum cleaner so that the filter
element can dry.

Cleaning the filter element

1
N
Switch on machine.
N
Squeeze sleeve (1, arrows) of hose
together to release it.
N
Pull hose off.
N
Seal the hose at the sleeve by firmly
pressing the sleeve against the flat
surface beside the switch.
N
Press the filter cleaning button 3
times.
Dust deposits are removed from the filter
element.
SE 122, SE 122 E