Webasto Air Top Evo 40 Einbauanweisung Seite 62

Air Top Evo 40 / Air Top Evo 55
IMPORTANT
Overheating of the heater due to blockage of the
heating air rotor!
Damage to the heater
 Ensure that the heater enclosure is not in contact with any
part of the heater in the installation position (see Fig. 3).
Fig. 3 After installation, the casing must not be in contact with
any parts of the vehicle body.
Determine the space requirement and the installation position (see Fig. 2,

Fig. 4 and Fig. 5).
Fig. 4 Permissible installation positions for the diesel heater
Technical information
Fig. 5 Permissible installation positions for the petrol heater
Observe the inclination angle (see Fig. 4 and Fig. 5).

NOTE:
The support area for the heater foot must be flat. The base
seal can compensate for unevenness of max. 1 mm.
 For unevenness on a larger scale, smooth out the mounting surface.
NOTE:
A special tool is available to drill the openings and to draw the
mounting surface flat (available from Webasto).
Drill the fastening holes and openings (see Fig. 39) using the drilling tem-

plate.
57