REHM INVERTIG.PRO 240 DC Betriebsanleitung Seite 95

Functio onal desc c ription
3.13.3 3 Explana ations for

Spe ecial parame eter, torch p
This s special par rameter is de
0 → → Torch poten
ntiometer is
evaluated
1 → → Torch poten
ntiometer is
torch is eva aluated

Spe ecial parame eter Up/Dow
This s special par rameter is de
0 → → Up/Down to
orch is inactiv
1 → → The Up/Do
own torch ca
When pulsi ing, the relat
2 → → The Up/Do
own torch c
Pressing th he rocker swi
3 → → Control of t
the cold wire

Spe ecial parame eter water c
0 → → Welding wi
ith a water-c
welding un nit to recogn
1400 or oth her water-coo
1 → → Welding wi
ith a water-c
recognises a function
Otherwise a an error mes
damaged s should the wa

Spe ecial parame eters AC cu
Sett ting the AC c curve shape
0 → → AC "Sine" c
curve shape
Noise-optim mised
1 → → AC "Triangl
le" curve sha
Better weld d penetration
2 → → AC "Rectan
ngle" curve s
Greatest po ossible arc st

Spe ecial parame eters for adj
Sett ting the adju ustment spe
burn ner buttons.
Valu ue range: 0 (slow) to 7
Not e
This s special par rameter is ac
set t to 1.
the speci al parame
potentiomete er SP1
esigned for u se with a torc
inactive, thus s the potenti
active, thus the set valu
wn torch SP2 2
esigned for u se with an U
ve, no Up/Do own function
n be used to o change the
ionship I /I i s maintained
1 2
can be used d to call up
itches to P2 (Up) and P1
unit APUS 2 20 C
ooling unit SP3
cooled torch is possible
nise a wate r-cooling un
oler without a a communica
cooled torch is only per
ing water-c ooler e.g. T
ssage occurs s which prev
ater-cooling u unit be missi
rve shape S SP4
in the "altern nating curren
ape
for "Sine" cu urve shape
shape
tability and h highest possi
justment sp eed for up/d
eed of weldi ng currents
7 (fast)
ctive if the "u p/down burn
eters
rch with pote ntiometer.
ometer on th he torch is no
ue of potentio ometer on th
Up/Down torc ch.
n available
e welding cu urrent I or I
1
d.
p programs P1 and P2
(Down).
without the need for th
nit e.g. TIG- COOL CAR
ation interfac ce.
rmitted if the e welding un
TIG-COOL CART 2000
vents the torc ch from bein
ing.
nt (AC)" polar rity
ible weld pen netration
down burne er SP5
I or I via the up/dow
1 2
ner" special p parameter 2
ot
GB
he
.
2
2.
he
RT
nit
0.
ng
wn
is
31 3