REHM INVERTIG.PRO 240 DC Betriebsanleitung Seite 105

Putting g into ope eration
5.8 Conne ecting ex
Externa al componen nts are conne
on the back of the e INVERTIG
are des scribed in ch hapter 4 (rem
COOL 2000 and T TIG-COOL C
connec ction is made e via a serial
Import tant!
When u using this 7- pin remote c
the dir rectives pert taining to th
electro magnetic co ompatibility (
provide ed by REHM .
Please note that th he length of
first an nd last subsc cribers must
serial c connection.
In orde r to ensure t that the exter
switch on the powe er switch of th
externa al devices.
xternal co omponen
ected via the e standard 7-
.PRO. These e include the
mote foot con ntroller P1, w
CART 2000, automation
CAN connec ction.
control socke et, please en
he use of serial bus s
EMC) specif fications. Alw
the INVERT TIG.PRO iSy
t not exceed d 20m beca
rnal connect ion is always
he INVERTIG G.PRO and t
nts
-pin remote c control socke
e Rehm acc cessories tha
water cooling devices TIG
interface). T The electrica
sure that yo u comply wit
systems. Pa articularly th
ways use the e accessorie
ystem cable between th
ause of the d design of th
s reliably initi ialised, first
then the swit tches of the
et
at
G-
al GB
th
he
es
he
he
41 4